新手求助：P630 故障 10111511
P630 7028-6C4
今天下午5点以前一切正常,shutdown关机后，楼上搬到楼下。
再次开机显示 4B23 26F7, 对照手册，断电后拆除 P1C2,然后插回。
开机 显示
10111511
这么怎摸回事呢，没有串口是不是提不出数据？
注： 没有hmc，串口线
我应该如何一步一步来查看解决，
求助啊求助啊
今天下午5点以前一切正常,shutdown关机后，楼上搬到楼下。
再次开机显示 4B23 26F7, 对照手册，断电后拆除 P1C2,然后插回。
开机 显示
10111511
这么怎摸回事呢，没有串口是不是提不出数据？
注： 没有hmc，串口线
我应该如何一步一步来查看解决，
求助啊求助啊
5同行回答
4B23 26F7 Description: 2-way processor card fault
Action: This error code indicates that the processor repeat gard function has
deconfigured a processor. Do the following:
1. Go to the processor configuration/deconfiguration menu, located under the
system information menu in the service processor menus.
Look at the status of the processors. If any of the processors have a status of
manually deconfigured, reconfigure the processor(s) and boot the system to
the SMS menus. Power off the system using the white power button and look
again at the status of the processors. If all of the processors are still
configured in the processor configuration/deconfiguration menu, the problem
has been resolved.
If any of the processors have a status of deconfigured by the system, either
before or after the boot to the SMS menus, go to step 2.
2. Replace the processor card (on which the deconfigured processor resides)
specified by the location code.收起
Action: This error code indicates that the processor repeat gard function has
deconfigured a processor. Do the following:
1. Go to the processor configuration/deconfiguration menu, located under the
system information menu in the service processor menus.
Look at the status of the processors. If any of the processors have a status of
manually deconfigured, reconfigure the processor(s) and boot the system to
the SMS menus. Power off the system using the white power button and look
again at the status of the processors. If all of the processors are still
configured in the processor configuration/deconfiguration menu, the problem
has been resolved.
If any of the processors have a status of deconfigured by the system, either
before or after the boot to the SMS menus, go to step 2.
2. Replace the processor card (on which the deconfigured processor resides)
specified by the location code.收起
浏览1932