做etherchannel需要注意的事项及环境要求

请注意，两网卡很贵，跟ha一样收起

两个网卡的属性一致..

要是光口都是光口,.,

电口都是电口收起

呵呵,那个是不是专用用hmc的呢收起

我以前遇到过
好想是IBM自己带的那种网卡不能与PCI的网卡跨网卡聚合
lsdev -Cc adapter中是hea的那种
很怪异收起

cannot mix other kinds of Ethernet devices into an EtherChannel.收起

smit chgenet 选择网卡的Media Speed                                         Auto_Negotiation/10M、100M、1000M、

smit etherchannel 绑定
是PIC的网卡配上IP要激活收起

When you assign a physical port to a Virtual I/O Server by enabling the promiscuous mode,the physical port is then dedicated for SEA use.
The LHEA (Ethernet interface for operating systems) can be used to create an EtherChannel device, even as the backup adapter, but it is not supported to mix an LHEA with other kinds of Ethernet device other than LHEAs (such as dedicated adapter ports). All standard EtherChannel features are available, such as backup adapter and ping dead gateway detection, to name a few.
When using LHEA ports in aggregation, all other partitions using the LHEA ports from the same physical HEA ports must also be in aggregation.收起

楼上回答无敌啊。呵呵。
首先主机要支持，其次要留有足够的联在SW上的端口，而且这些端口要未配置，而且必须设成同样的速度、工作模式。
剩下就是smitty添加配置了呗，其他没啥了吧？好像还要调网络参数，但具体调什么不记得了。收起

一块网卡能配成，只是没意义而已，哈哈，收起

没啥啊，只要至少两个网口就可以了，基于安全考虑，不同网口应该在不同网卡上收起