Configure IP-based Networks Configure Non IP-based Networks
Add an IP-based Network
Type or select values in entry fields. Press Enter AFTER making all desired changes.
[Entry Fields] * Network Name [tcp_1] * Network Attribute public + Network Type [ether] + Subnet(s) [192.168.1.0/24] +
Configure Adapters
Move cursor to desired item and press Enter.
Configure IP-based Interfaces / IP Labels Configure Adapters on Non IP-based networks
Configure IP-based Interfaces / IP Labels
Move cursor to desired item and press Enter.
Add Initial Interfaces Discover IP Topology Add Multiple IP-based Interfaces Add Multiple Service IP Labels to a Network Add IP Labels Requiring Individual Configuration Change / Show an Interface / IP Label Remove Interface(s) / Label(s)
Add an Initial Interface
Type or select values in entry fields. Press Enter AFTER making all desired changes.
[Entry Fields] * IP Label [servera_boot] Network Type ether Network Name tcp_1 * Interface Function [boot] Interface IP Address [198.162.1.1] * Node Name [servera] Netmask [] 就这样把所有节点中的boot、service和standby网卡都设好。注意Network Name要和hosts里的label一样。Ip地址和netmask可以自动从hosts中获得。 下面设置心跳: Add a Non IP-based Network
Type or select values in entry fields. Press Enter AFTER making all desired changes.
[Entry Fields] * Network Name [serialnet0] * Network Type [rs232]
Add a Non IP-based Adapter
Type or select values in entry fields. Press Enter AFTER making all desired changes.
[Entry Fields] * Adapter Label [servera_tty] Network Type rs232 Network Name serialnet0 * Device Name [/dev/tty3] * Node Name [servera] 把所有的节点的心跳都配置好拓扑就ok了。 下面同步拓扑结构: Synchronize Cluster Topology
Type or select values in entry fields. Press Enter AFTER making all desired changes.
Note: Only the local node's default configuration files keep the changes you make for topology DARE emulation. Once you run your emulation, to restore the original configuration rather than running an actual DARE, run the SMIT command, "Restore System Default Configuration from Active Configuration." We recommend that you make a snapshot before running an emulation, just in case uncontrolled cluster events happen during emulation.
NOTE: If the Cluster Manager is active on this node, synchronizing the Cluster Topology will cause the Cluster Manager to make any changes take effect once the synchronization has successfully completed. HACMP全攻略之安装与配置2