问题描述：
A机 有网卡：ent0 ent1 ent2 ent3 ent5
B机 有网卡：ent0 ent1 ent2 ent3 ent5
HACMP以前配置是：启动地址在ent3和 备用地址是ent5 （两台主机都是）
现在B机的ent3 ent5 由于硬件故障，不能恢复，当前状态不可用了；
于是，就把当前B机的ent3和ent5 上的ip地址修改到ent1 和ent2 ，修改了hacmp的网络拓扑和自由组的相关信息后
结果做hacmp的同步，有报错，如下：
Verification to be performed on the following:
Cluster Topology
Cluster Resources
Retrieving data from available cluster nodes.
This could take a few minutes........
Verifying Cluster Topology...
ERROR: The HACMP adapter en5 is not available on node B_HOST
ERROR: The HACMP adapter en3 is not available on node B_HOST
WARNING: There may be an insufficient number of communication interfaces defined on node: uipdb1, network: net_ether_01.
Multiple communication interfaces are recommended for networks that will use IP aliasing.
WARNING: There may be an insufficient number of communication interfaces defined on node: uipdb2, network: net_ether_01.
Multiple communication interfaces are recommended for networks that will use IP aliasing.
WARNING: There may be an insufficient number of communication interfaces defined on node: uipdb1, network: net_ether_02.
Multiple communication interfaces are recommended for networks that will use IP aliasing.
WARNING: There may be an insufficient number of communication interfaces defined on node: uipdb2, network: net_ether_02.
Multiple communication interfaces are recommended for networks that will use IP aliasing.
Verifying Cluster Resources...
------现在问题是：
1、
A机 有网卡： ent3 ent5
B机 有网卡：ent1 ent2
网卡端口不对应，hacmp可以做吗？
2、如果可以，通过修改哪些选项，可以完成hacmp的同步呢？
收起