IBM System Storage DS Storage Manager Version 11.2 Installation and Host Support

IBM System Storage DS Storage Manager Version 11.2

Installation and Host Support Guide

Lists the tasks for installing the Storage Manager and supporting the host

computer. The tasks include determining the hardware and software, integrating

hardware with the network, installing the Storage Manager software, and using

features of the Storage Manager.

This document provides information about how to plan, install, configure, and

work with the IBM ® System Storage ® DS Storage Manager Version 11.20 or later,

and for storage subsystems with controller firmware version 7.8x.xx.xx or later. If

the IBM DS Storage Manager is earlier than 11.20, refer to IBM System Storage DS

Storage Manager Version 10 - Installation and Host Support Guide. This document

is intended for system and storage administrators who are responsible for

installing storage administration software. To install and manage a storage

subsystem with Storage Manager, you must have knowledge of redundant array of

independent disks (RAID), small computer system interface (SCSI), Fibre Channel,

and SATA technology. You must also have working knowledge of the applicable

operating systems that are used with the management software.

Note: The screenshots in the guide are illustrative and may differ from the actual

UI depending on the Storage Manager and controller firmware versions.

Throughout this document, the term Storage Manager refers to all host software

release levels.

Use this document to perform the following tasks:

v Determine the hardware and software that are required to install Storage

Manager.

v Integrate the necessary hardware components into your network.

v Install the Storage Manager software.

v Upgrade controller firmware, if necessary.

v Identify and use storage-management features that are unique to your

installation