powerha 定义 service ip 报错
设备环境: P5 520 主机*1
LPAR *2
Brocade 200E *2
EMC CX300
软件环境: AIX 6100-04-01-0944
PowerHa 6.1.0.0
PowerPath 4.5.1.0
ODM 5.3.0.5
navisagent 6.19
IP规划:
127.0.0.1 loopback localhost # loopback (lo0) name/address
192.168.9.51 node1-boot node1
192.168.9.52 node1per
10.0.0.1 node1-priv
192.168.9.55 node2-boot node2
192.168.9.56 node2per
10.0.0.2 node2-priv
192.168.9.26 Cloud-I7
192.168.9.53 node1svc
192.168.9.54 node2svc
心跳磁盘已经做好了
hdiskpower1 00ce535b517be873 mndhb_vg_02
配置 smitty hacmp -> Extended Configuration ->
Extended Resource Configuration -> HACMP Extended Resource Configuration
configure hacmp service IP Lables/Addresses -> Add a Service IP Label/Address
Configurable on Multiple Nodes > net_ether_01 (10.0.0.0/24) ->
IP Label/Address node2svc +
Netmask(IPv4)/Prefix Length(IPv6) []
* Network Name net_ether_01
Alternate Hardware Address to accompany IP Label/A []
ddress
回车确认时返回如下错误信息
Command: failed stdout: yes stderr: no
Before command completion, additional instructions may appear below.
Error: There is either no node with communication interface defined, or service IP label is bou
nd to the node, so this dynamic service IP label (node1svc) can not associate to any node. Ens
ure that the service label is on the correct boot adapter subnet and that there is a communicat
ion interface defined on that node.
ERROR: write_config_file failure
我有点想不明白,我只在/etc/hosts 上面定义了 service IP ,实际 VIP并没有被使用,PING的结果如下
bash-4.2# ping node1svc
PING node1svc: (192.168.9.53): 56 data bytes
我想做的并发的HA环境,请大家帮忙指导一下?